This is just onetime simple job.

I  am attaching an image of a clock dial. Look at image name NAME.
I need to reproduce the same lettering and design to make another dial by etching on brass. I am not able to get the exact fonts and flourish. The same design will have two different numbers under LONDON 8982  and 8477.

(PL KEEP IN MIND THE DEPTH OF THE LETTERS WHICH IS NOT UNIFORM AND GOES FROM THIN AND FAINT TO BROAD AND DEEP IN SAME LETTERS TOO.)

It would be in autocad or coral draw.

I should have the flexibility to move LONDON above the central hole (from where the two hands originate) or below the central hole. And depending upon the size of the dial, size of these lettering would also change to maintain proportionality. Source code/editable file would be needed.

Was I clear?

Thanks